The main objective of this work was to study the effect of plastic deformation (cold work) and heat treatment on the hydrogen permeation of a seamless carbon steel pipe, commonly used in the oil industry, considering the relationship between microstructure and hydrogen diffusion. The steel samples were characterized, by scanning and transmission electron microscopies to establish the relationship between microstructure and defects on the hydrogen damage.

The hydrogen permeation tests were performed on samples of the above mentioned steel in the different conditions. The experiments were carried out following the Devanathan and Stachurski technique, using 0.1M Na2SO4 as the electrolyte in the cathodic compartment and 0.1 M NaOH as the electrolyte in the anodic one. The obtained results showed that the hydrogen absorption capacity is higher when the steel has the larger deformation degree. This could be associated to the presence of substructures with small cell size range (0.01-0.15 μm), meaning a higher dislocation density, which could act as a preferential site for a greater hydrogen absorption and transportation. On the other hand, with increasing deformation, the mean hydrogen flux is greater than measured through steel in the as received condition.

Subject
Scanning electron microscopy, Hydrogen permeation, Hydrogen damage, Deformation, Dislocation, Microstructure, Diffusion, Transmission electron microscopy, Micrography, Density, Heat, Steel, Hydrogen
Keywords:
Steel, hydrogen damage, hydrogen permeation, cold work
© 2010 Association for Materials Protection and Performance (AMPP). All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means (electronic, mechanical, photocopying, recording, or otherwise) without the prior written permission of AMPP. Positions and opinions advanced in this work are those of the author(s) and not necessarily those of AMPP. Responsibility for the content of the work lies solely with the author(s).
2010
Association for Materials Protection and Performance (AMPP)
You do not currently have access to this content.