Microstructural evolution and mechanical behavior of austenitic stainless steels are evaluated for neutron and heavy-ion irradiated materials. Radiation hardening in austenitic stainless steels is shown to result from the evolution of small interstitial dislocation loops during light-water-reactor (LWR) irradiation. The presence of these loops modifies deformation characteristics and prompts a significant increase in yield strength. Available data on stainless steels irradiated under LWR conditions have been analyzed and microstructural characteristics assessed for the critical fluence range (0.5 to 5x1021 n/cm2) where irradiation-assisted stress corrosion cracking susceptibility is observed. Heavy-ion irradiations are used to produce similar defect microstructures enabling the investigation of hardening and deformation mechanisms. Scanning electron, atomic force and transmission electron microscopies are employed to examine tensile test strain rate and temperature effects on deformation characteristics. Dislocation loop microstructures promote inhomogeneous planar deformation within the matrix and regularly spaced steps at the surface during plastic deformation. Twinning is the dominant deformation mechanism at rapid strain rates and at low temperatures, while dislocation channeling is favored at slower strain rates and at higher temperatures. Both mechanisms produce highly localized deformation and large surface slip steps. Channeling, in particular, is capable of creating extensive dislocation pileups and high stresses at internal grain boundaries which may promote intergranular cracking.

Subject
Strain rate, Materials, Deformation, Dislocation, Microstructure, Irradiation, Irradiation assisted stress corrosion cracking, Density, Intergranular cracking, Defects, Stainless steel, Slip, Grain boundary
© 1997 Association for Materials Protection and Performance (AMPP). All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means (electronic, mechanical, photocopying, recording, or otherwise) without the prior written permission of AMPP. Positions and opinions advanced in this work are those of the author(s) and not necessarily those of AMPP. Responsibility for the content of the work lies solely with the author(s).
1997
Association for Materials Protection and Performance (AMPP)
You do not currently have access to this content.