... to apply cleaning for corrosion control. ^‡ Corresponding author. E-mail: [email protected] . 10 May 2023 28 November 2023 28 November 2023 © 2024, AMPP 2024 aircraft rinsing atmospheric environments chloride weight loss C orrosion is one...

...-mail: [email protected] . 25 October 2020 02 February 2021 02 February 2021 © 2021, NACE International 2021 carbon steel corrosion monitoring corrosion rate convolutional neural network deep learning weight loss FIGURE 2. Monitored target bridges located...

... nickel-copper alloys weight loss In NaCl solution (Figure  2[a] ), values for NAB exposed to continuous cavitation erosion were much larger than that exposed to the pulse process. After effective cavitation corroded for 8 h, the total mass loss caused by continuous cavitation was 21.45±0.75 mg...

... of the condensed liquid has confined the majority of TLC studies to the weight loss method which only provides integrated corrosion rate over long period of exposure. The instantaneous monitoring of TLC rates using electrochemical methods is still a challenge for researchers and in the field. To overcome...

... exposed. aqueous environment corrosion rate hydrogen evolution magnesium Mg-Sn-Zn alloys microstructure weight loss Relatively low absolute strength and poor corrosion resistance have restricted the application of magnesium alloys to various industries despite their many advantages...

...-mail: [email protected] . 15 9 2015 20 11 2015 © 2016, NACE International 2016 acid solutions intergranular corrosion oxidation scanning electron microscope stainless steel weight loss This study examines the initial oxidation behavior and corrosion performance under...

... of the Cu₂O layer. FTIR spectra suggest that sulfate, silicate, and/or hydroxyls are likely to be present. 23 3 2015 13 5 2015 13 5 2015 © 2015, NACE International 2015 chloride copper corrosion resistance soils Steinrath index weight loss Underground metallic...

... for electrochemical measurements. carbon dioxide corrosion electrochemical impedance spectroscopy low-alloy steel weight loss x-ray photoelectron spectroscopy Sweet corrosion has been one of the most widespread and prominent problems in the oil and gas industry for a long period. 1– 2 Carbon...

..., 40449 Matanzas, Cuba 12 3 2014 30 6 2014 30 6 2014 © 2014 NACE International 2014 atmospheric corrosion electrochemical impedance spectroscopy organic coatings scanning electron microscopy weight loss x-ray diffraction The corrosion protection of metallic...

...Q.L. Xie; W.M. Chen; Q. Yang The influence of sulfur anions known to exist in sulfide-containing Bayer solutions on the corrosion of 16Mn low-alloy steel was investigated by laboratory tests. The high-temperature weight-loss tests, means of anodic polarization curves, and cyclic voltammetry were...

...Feng Huang; Tengwei Zhu; Xuejun Zhou; Jing Liu; Jiqing Chen The indoor accelerated corrosion of 09CuPCrNi weathering steel in simulated industrial atmosphere was investigated by the corrosion weight-loss method, field emission scanning electron microscopy (FE-SEM), x-ray diffraction (XRD...

... corrosion acid solution cast iron weight loss Cast iron is widely used for pipes in neutral environments such as water and soil. A lot of experimental studies of cast iron for practical use were conducted. 1–10 A form of corrosion unique to cast irons is a selective leaching attack commonly...

[email protected] . ^*Department of Chemical Engineering, University of Vigo, 36310 Vigo, Spain. ^**Department of Science Materials, University of Vigo, 3630 Vigo, Spain. marine environment steel weight loss x-ray diffraction Atmospheric corrosion, as a result...

... machined from an X-65 pipe section. The coupons were ground to 600 grit and then cleaned in acetone (CH₃COCH₃) and ethanol (C₂H₆O) prior to each test. cathodic protection corrosion disbonded coating electrochemical polarization weight loss...

..., few attempts have been made to capture the corrosion and erosion components of damage. © 2013 NACE International 2013 carbon steel erosion erosion-corrosion heat-affected zone inhibitors weight loss weld TABLE 2 Composition of Brine Used in Static Corrosion, Flow-Induced...

...) and O₂, the understanding of exposure time on the corrosion rate is inadequate. In the present work, the weight-loss method was used to study the effect of exposure time on the corrosion rates of X70 steel in supercritical CO₂/SO₂/O₂/H₂O. Morphology analysis...

... ions, at 170°C. Weight-loss coupons of austenitic, superferritic, and DSS alloys were used to study the influence of alloy composition. SCC susceptibility of UNS S32205 and S32101 was evaluated in 150 g/L sodium hydroxide (NaOH, 3.75 M) and 50 g/L sodium sulfide (Na₂S, 0.64 M) with 0 to 100...

...R. Ali Rahimi; S.K. Sadrnezhaad Corrosion of lead silicate glass (LSG) contacting 0.5 M aqueous nitric acid (HNO₃) was investigated via scanning electron microscopy, energy-dispersive spectroscopy, inductively coupled plasma analysis, and weight-loss measurement to determine...

... International 2012 hydrogen evolution magnesium pitting corrosion weight loss The corrosion behavior of Mg alloys is influenced greatly by their composition and level of impurities. Al, Zn, and Mn are the main alloying elements in the AZ alloys series, which are the most widely used Mg alloys...

... but complete protection is probably not possible. These conditions are being studied in the laboratory using artificial seawater and protection current densities less than would be normally applied in practice. Experiments involving weight loss, alternating current (AC) impedance, and surface analysis...