Gasoline Resistant Tank Coatings. Corrosion, 8, No. 6, 195-204 (1952) June.
Page 195. Delete from the abstract the fourth paragraph beginning: “A discussion of the problems of coating . . . ."
Page 197, substitute the paragraphs below for those in column one beginning with the words : “Figure 6 . . .”
The polysulfide-type material was applied at an average thickness of 13.1 mils (52 measurements taken ; minimum reading, 8 mils ; maximum reading, 19 mils). This involved an initial brush coat, followed by three spray coats. The vinyl-type material was applied at an average thickness of 7.4 mils (53 measurements taken ; minimum reading, 5 mils ; maximum reading, 12 mils). This involved an initial brush coat, followed by five spray coats. The Saran-type material was applied at an average thickness of 7.1 mils (35 measurements taken; minimum reading, 5 mils; maximum reading, 10 mils)....
